No Mounting Hardware Used; Securing Drive, Mounting Hardware Used - HP DW017B - StorageWorks Ultrium 448 Tape Drive User Manual

1. Plastic rail
2. Server latch
Figure 16 Securing drive, mounting hardware used
2.
Ensure blanking plates are in place over empty bays and replace the cover on the server.

No mounting hardware used

1. Use the M3 screws provided with the tape drive in the screw pack labeled 'General Mounting
Screws'. Check that the holes in the chassis are aligned with the holes in the sides of the drive and
use a regular Phillips screwdriver to secure the M3 screws, as shown in
If you cannot tighten the screws, use the washers provided in the pack.
34
Installing an internal Ultrium tape drive
Figure 17 on page 35.