Reboot The Server; Sticker For Highest-Numbered Hard Disk Bay - HP DW017B - StorageWorks Ultrium 448 Tape Drive User Manual

Half-height sas tape drives

Hide thumbs Also See for DW017B - StorageWorks Ultrium 448 Tape Drive:

Release note (4 pages)

Start here (2 pages)

Connection manual (1 page)

Table Of Contents

Table of Contents

Connect the other end of the SAS cable (threaded through the blanking plate to the outside of the

server) to the connector on the rear of the tape drive.

Plug the power cord securely into the socket on the rear panel of the drive and plug the other

end of the power cord into the power outlet. The power on/off switch is on the front panel, see

Figure 26

1. SAS connector

2. Power connector

Figure 26 Connecting the cables to the tape drive

CAUTION:

Never use a cable where power is supplied through the SAS connector because this may

damage the drive. For external drives, always use the supplied power cord.

10.

If you have lost the use of a disk bay (see

attach the supplied sticker to the blanking plate of the disk bay to show that it is disconnected.

NOTE:

If you subsequently install a hard disk in this bay, it will not work. This does not mean there

is a fault with either the disk or the server.

Figure 27 Sticker for highest-numbered hard disk bay

11.

Now go to