Table of Contents
Advertisement
HIGH ALTITUDE MODE
If you use the projector at high elevation (1 400 m to
2 700 m), the [HIGH ALTITUDE MODE] setting needs
to be [ON] to set the fan speed high.
1 )
Press ▲▼ to select [HIGH ALTITUDE
MODE].
2 )
Press ◄► to switch [HIGH ALTITUDE
MODE] and press <ENTER> to select.
The setting will change as follows each time
z
◄► is pressed.
OFF
Select this when using in normal
OFF
environment (less than 1 400 m
above sea level)
Select this when using at high
ON
altitude (above 1 400 m and less
than 2 700 m above sea level)
3 )
When the confirmation message is
displayed, select [OK] or [CANCEL].
Note
The loudness of fan noise depends on the [HIGH
z
ALTITUDE MODE] setting.
The separately-sold Smoke Cut Filter cannot be used
z
when the [HIGH ALTITUDE MODE] is [ON].
LAMP POWER
Can switch the electric power of projector lamp. Set
the lamp power to meet the environment and purpose
of projection.
1 )
Press ▲▼ to select [LAMP POWER].
2 )
Press ◄► to switch [LAMP POWER].
The setting will change as follows each time the
z
button is pressed.
NORMAL
NORMAL
Sets the normal lamp intensity.
ECO
Sets the reduced lamp intensity.
Note
The [ECO] mode can reduce the power
z
consumption, reduce the operation noise, and
increase the service life of projector lamp.
The [LAMP POWER] may not drop automatically if:
z
•
You have set the [LAMP POWER] to [NORMAL].
•
Automatic power drop may fail immediately after
the lamp is turned on or the [LAMP POWER] is
set.
ECO MANAGEMENT
Can optimize lamp power and reduce the power
consumption according to the application.
1 )
Press ▲▼ to select [ECO
MANAGEMENT].
2 )
Press <ENTER> button.
The [ECO MANAGEMENT] screen is displayed.
z
3 )
Press ▲▼ to select ECO
MANAGEMENT.
4 )
Press ◄► to switch the setting.
ON
AUTO POWER SAVE
J
[AMBIENT LIGHT DETECTION],
[SIGNAL DETECTION], and [AV MUTE DETECTION]
functions can be used.
1.
Select [AUTO POWER SAVE] in Step 3.
2.
Press ◄► to switch [AUTO POWER
SAVE] setting.
The setting will change as follows each time the
z
button is pressed.
3.
Press ▲▼ to select AUTO POWER
SAVE conditions.
AMBIENT LIGHT
DETECTION
SIGNAL
DETECTION
AV MUTE
DETECTION
4.
Press ◄►to enable or disable the
selected condition.
The setting will change as follows each time the
z
button is pressed
ECO
PROJECTOR SETUP menu
ON
Adjusts the lamp power according
to the ambient brightness.
Drops the lamp power when no
signal is input.
Drops the lamp power in the AV
Mute mode.
ON
OFF
OFF
63
ENGLISH -
Hide quick links:
Advertisement
Table of Contents
