Table of Contents
Advertisement
Pin assignments and signal names of <DVI-D IN> terminal
J
Outside view
:
The PT-DX500U has the same DVI-D input terminal with the 180-degree rotated pin layout.
Û
Connecting example : AV equipment
DVD player
with HDMI terminal
Attention
When connecting with a video deck, be sure to use the one with a built-in time base corrector (TBC) or use a TBC between
z
the projector and the video deck.
If nonstandard burst signals are connected, the image may be distorted. If this is the case, connect a TBC between the
z
projector and the video deck.
Note
When using an HDMI cable, check that it is compliant with the HDMI standard. Using a cable that is not compliant with the
z
HDMI standard may result in problems such as the image cutting out or not appearing.
When connecting the 1 080p signal using HDMI, use a cable compliant with 1 080p signal.
The HDMI terminal supports voice signals having 48 kHz, 44.1kHz and 32kHz linear PCM sampling
z
frequencies only. For the supported video signals, see "List of compatible signals."
It is possible to connect the HDMI input terminal with an external device having a DVI terminal using an HDMI/DVI
z
conversion cable, but with some devices the images may not appear or other problems may occur. (
It is possible to connect the DVI-D input terminal with an HDMI- or DVI-D compliant device, but with some devices the
z
images may not appear or other problems may be encountered in operation. (
Pin No.
Signal names
T.M.D.S data 2 -
T.M.D.S data 2+
T.M.D.S data 2/4 shield
—
—
DDC clock
DDC data
—
T.M.D.S data 1 -
T.M.D.S data 1+
T.M.D.S data 1/3 shield
—
Video deck
(TBC built-in)
or
Connections
Pin No.
Signal names
+5V
GND
Hot plug detection
T.M.D.S data 0 -
T.M.D.S data 0+
T.M.D.S data 0/5 shield
T.M.D.S clock shield
T.M.D.S clock +
T.M.D.S clock -
Audio system
Æ
(
page 87)
Æ
page 57)
Æ
page 57)
ENGLISH -
—
—
—
29
Hide quick links:
Advertisement
Table of Contents
