Connections; Before Connection To The Projector - Panasonic PT-DW530U Operating Instructions Manual

Connections

Before connection to the projector

Read carefully the instruction manual for the device to be connected.
z
Turning off the power switch of the devices before connecting cables.
z
If any connection cable is not supplied with the device, or if no optional cable is available for connection of the
z
device, prepare a necessary system connection cable to suit the device.
Video signals containing too much jitter may cause the images on the screen to randomly wobble or wafture.
z
In this case, a time base corrector (TBC) must be connected.
The projector accepts the following signals: VIDEO, S-VIDEO, analogue-RGB (with TTL sync. Level) and
z
digital signal.
Some computer models are not compatible with the projector.
z
When using long cables to connect with each of equipment to the projector, there is a possibility that the image
z
will not be output correctly unless a compensator is used.
Pin assignments and signal names of <S-VIDEO IN> terminal
J
Outside view
Pin assignments and signal names of <RGB2 IN> terminal
J
Outside view
Pin assignments and signal names of <HDMI IN> terminal
J
Outside view
Odd-numbered pins
Even-numbered pins
28
- ENGLISH
Pin No.
GND (luminance signal)
GND (color signal)
Luminance signal
Color signal
Pin No.
R/P
G/G SYNC/Y
B/P
DDC data
HD/SYNC
VD
DDC clock
Pin No.
T.M.D.S data 2+
T.M.D.S data 2 -
to
T.M.D.S data 1 shield
T.M.D.S data 0+
T.M.D.S data 0 -
T.M.D.S clock shield
CEC
SCL
to
DDC/CEC GND
Hot plug detection
Signal names
Signal names
R
B
Signal names Pin No.
, : Not assigned
- , , : GND terminals
Signal names
T.M.D.S data 2 shield
T.M.D.S data 1+
T.M.D.S data 1 -
T.M.D.S data 0 shield
T.M.D.S clock +
T.M.D.S clock -
—
SDA
+5V