Rs-232C - Panasonic PT-DW530U Operating Instructions Manual

4 ) Press ▲▼ to select [TIME] or
[COMMAND] and change the setting
according to the instructions of the
menu.
Set the time at which the command
TIME
will be executed using ▲▼ buttons.
Select a command to execute at the
set time from the following.
• POWER ON
• STANDBY
• AV MUTE ON
AV MUTE OFF
•
INPUT RGB1
•
• INPUT RGB2
• INPUT VIDEO
COMMAND
• INPUT S-VIDEO
• INPUT DVI-D
• INPUT HDMI
INPUT
•
NETWORK
• LAMP POWER
NORMAL
• LAMP POWER
ECO
5 ) Press ▲▼ to select [STORE] and
press <ENTER> button.
Note
If you try to register a setting that would cause the lamp to
z
flash for a short time, an error message will be displayed on
the screen. Set the [TIME] and [COMMAND] again.
To delete a command which has been set, press
z
<DEFAULT> button.
If multiple commands have been set for the same time,
z
they are executed in chronological order starting from the
smallest command number.
The setting time operates under the local time.
z
( Æ page 67)
If an operation is executed with the remote control or
z
control panel of the projector or with a control command
before the command set in the schedule is executed, the
command set with this function may not be executed.

RS-232C

This sets the communication parameters at the serial
terminals.
1 ) Press ▲▼ to select [RS-232C].
2 ) Press <ENTER> button.
The [ RS-232C] screen will be displayed.
z
3 ) Press ▲▼ to select communication
conditions.
4 ) press ◄► to change the setting.
Note
z
J
When using the control commands for one of our
projectors that you have previously purchased to
control this projector using a computer via its serial
input terminal, set up the EMULATE function as
follows. This will allow you to use the control software
etc. designed for our existing projectors.
• SIDE BY SIDE
1.
MODE OFF
• SIDE BY SIDE
2.
MODE1
3.
SIDE BY SIDE
•
MODE2
4.
• SIDE BY SIDE
MODE3
● DEFAULT
• SIDE BY SIDE
MODE4
IN STANDBY
•
MODE (AUDIO)
ON
• IN STANDBY
MODE (AUDIO)
OFF
VOLUME
•
PROJECTOR SETUP menu
Æ
Refer to "Serial terminal" (
Selecting items in [EMULATE]
Select [EMULATE] in step 3).
Press <ENTER> button.
Press ▲▼ to select the required item.
Press <ENTER> button.
DZ570 Series, DW530 Series,
DX500 Series
L730 L520 Series, L720 Series,
SERIES L730 Series
L780
L750 Series, L780 Series
SERIES
L735
L735 Series
SERIES
L785
L785 Series
SERIES
F100 Series, FW100 Series,
F SERIES F200 Series, F300 Series,
FW300 Series
LB75 Series, LB78 Series,
LB80 Series, LB90 Series,
LB SERIES
LB1 Series, LB2 Series,
ST10 Series
page 82).
ENGLISH -
65