Adjusting The Height - Sharp PG-F200X - Notevision XGA DLP Projector Operation Manual

3 Adjusting the Height

The height of the projector can be ad-
justed using the adjustment feet at the
front and rear of the projector.
When the screen is above the projec-
tor, the projection image can be made
higher by adjusting the projector.
1
Lift the projector to adjust its
height while lifting the HEIGHT
ADJUST lever.
2
Remove your hands from the
HEIGHT ADJUST lever of the pro-
jector after its height has been
finely adjusted.
• The angle of projection is adjustable up
to approx. 9 degrees from the surface on
which the projector is placed.
3
Use the rear adjustment foot to
make the projector level.
• The projector is adjustable ±2 degree
from the standard position.
Note
• When adjusting the height of the projector,
trapezoidal distortion occurs. Follow the pro-
cedures in Keystone Correction to correct the
distortion. (See pages
Info
• Do not apply too much pressure on the pro-
jector when the front adjustment foot comes
out.
• When lowering the projector, be careful not to
get your fingers caught in the area between
the adjustment foot and the projector.
• Hold the projector firmly while lifting or carrying.
• Do not hold by the lens area.
28 and 41.)
HEIGHT
ADJUST lever
Make small
adjustments.
Rear adjustment foot
27