Cf_P-Manetime Command; Cf_On-Sta Command; Cf_Ccaptiondisp Command; Cf_Ccaptioncolor Command - Sanyo PDG-DWL2500 - 2500 Lumens Functional Specifications

PDG-DWL2500 Expand Serial Command Functional Specifications
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.10.19 CF_P-MANETIME Command

Command "CF_P-MANETIME_%1"[CR]
"01" ~ "30" ----------------------- Directly select setting time by the minute
"UP" ------------------------------- Plus one minute (01 → 02 → ÿ e ÿ e ÿ e → 30 → 01)
ÿ ÿ
"DN" ------------------------------- Minus one minute(30 → 29 → ÿ e ÿ e ÿ e → 01 → 30)
Set Power Management time
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.10.20 CF_ON-STA Command

Command "CF_ONÿ STA_%1"[CR]
"ON" --------------------------- Set Direct on active
"OFF" ------------------------- Set Direct on inactive
"UP" --------------------------- Switch setting (On → Off → On → ÿ e ÿ e ÿ e )
%1
"DN" --------------------------- Switch setting (On → Off → On → ÿ e ÿ e ÿ e )
Note) "UP" and "DN" behave the same.
Set/Cancel Power ON Start
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.10.21 CF_CCAPTIONDISP Command

Command "CF_CCAPTIONDISP_%1"[CR]
"OFF" ------------- Select Off
"CC1" ------------- Select CC1
%1 "CC2" ------------- Select CC2
"CC3" ------------- Select CC3
"CC4" ------------- Select CC4
Select channel of Closed caption.
The status set with this command is stored in EEPROM and its setting is effective
even after ALL is OFF.
Details This command is available in normal Power ON status.
Note)Closed caption is available under conditions below;
Entered signal is appropriate (Video, NTSC signal of S-video).
Acceptable
Response
Unacceptable

8.10.22 CF_CCAPTIONCOLOR Command

Command "CF_CCAPTIONCOLOR_%1"[CR]
%1 "COLOR" ------- Select Color
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
40/72