PDG-DWL2500 Expand Serial Command Functional Specifications
The status set by this command is stored in EEPROM and the setting remains
even after the power is turned to ALL OFF status.
*When ÿ
Capture non-practice.
Acceptable
Response
Unacceptable
8.10.12 CF_DISP Command
Command
"CF_DISP_%1"[CR]
"ON" ----------------------------- Select Display
"OFF" --------------------------- Cancel Display
%1
"CNTDWNOFF" -------------- Count down OFF
"UP" --------------- The same operation as pressing Up key or Left key
"DN" ---------------The same operation as pressing Down key or Right key
Set / Cancel Display
The value set by this command is stored in EEPROM and its setting is effective
Details
even after ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.10.13 CF_LOGO Command
Command
"CF_LOGO_%1_%2"[CR]
%1
"0000"-"9999" ----------------- Set LOGO PIN CODE directly
"OFF" ---------------------------- Disable Logo function
"DFLT" --------------------------- Display Default Logo
"USER" -------------------------- Display Captured Logo
%2
"UP" --------------- The same operation as pressing Up key or Left key
"DN" ---------------The same operation as pressing Down key or Right key
Set / Cancel Logo
The value set by this command is stored in EEPROM and its setting is effective
even after ALL is OFF
This command is available in normal Power ON status.
%1--- Set LOGO PIN CODE
- When LOGO LOCK is in operation
PIN CODE is correct ------------------ Command is valid (Acceptable)
PIN CODE is incorrect ---------------- Command is invalid (Error Code "102")
Details
PIN CODE is out of %1 range ------ Command is invalid (Error Code "? ")
-When LOGO LOCK is not in operation
PIN CODE is within %1 range ------ Command is valid
PIN CODE is out of %1 range ------ Command is invalid (Error Code "? ")
Note) Receiving correct LOGO PIN CODE while LOGO LOCK is in operation
enables to change LOGO setting, but it does not release LOGO LOCK. (LOGO
LOCK continues.)
Projector returns Error Code "101" by receiving USER in %2 when capture has not
operated.
Acceptable
Response
Unacceptable
8.10.14 CF_ HDMI SETUP Command
Command
"CF_ HDMI SETUP _%1"[CR]
1="USER" is received, error code "101" is returned, in the case of
"000" [CR]
"Error Code" [CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
38/72