Table of Contents
Advertisement
2. Remove
the broiler pan and grill, all
cookware,
utensils and other loose i tems
from the oven c hamber.
Also, remove all
oven r acks a nd the convection
fan filter t o
prevent them from permanently
discoloring.
However,
toclean s tubborn
particles inthe
convection
filter you may elect tosimply
leave i tinplace d uring self-clean.
The filter
will d iscolor due tothe high h eat, but t his
will n ot h arm the filtering capabilities
3. Wipe u pexcess grease and other food
spills w ith adamp cloth. This w ill m inimize
smoke and increase the efficiency
ofthe
Self-Clean
cycle.
4. Turn o nkitchen fans o rvents t ohelp
remove odors d uring the Self-Clean
cycle.
[_ IMPORTANT:
If racks are left in the oven during a Self-
Clean cycle, it will affect their
ability to slide
in and out easily. Polish the rack edges with
a soapy steel wool pad, then apply a small
amount
of vegetable
oil to the edges so that
the racks will slide more easily.
Follow these steps to Self-Clean
the oven:
1
Complete all steps listed above for
preparing the oven for Self-Cleaning.
2
Close the oven door completely
3
Press the "SELF-CLEAN"
touch pad The
oven will beep once, "CLEAN" will flash,
and "- -:--"
will be displayed.
4.
Press the "TIME,TEMP"
"+" pad and
the default time of "2:00" hours will be
displayed.
5.
Increase the self-clean time up to 4 hours
(depending upon the amount of oven soil)
by holding the "TIME,TEMP"
"+" pad.
6.
To delay the self-clean start to a more
convenient time, press the "STOP TIME"
touch pad. Then, press the "TIME,TEMP"
"+" pad to set the time of day for the
cycle to be complete.
"DELAY TIMED" will
appear in the clock display. The cycle can
be delayed up to 11 hours and 50 minutes.
7.
Approximately
30 to 60 seconds after
selecting Self-Clean,
the automatic door
latch will lock the door. "LOCK" and "ON"
will appear in the clock display. The oven
will begin heating. The "ON" indicator will
cycle on and off with the burner.
_
NOTE:
If Delay Timed mode has been set, the "ON"
display
and the oven heat will not turn
on until the programmed
time has been
reached.
[_
IMPORTANT:
If the door is not closed
completely,
the
automatic
door latch will not be able to
lock the door when the Self-Clean
mode
is selected.
In this case, "door"
will flash
in the clock display.
If this occurs,
press
the "CANCEL.SECURE"
pad and wait
approximately
1 minute.
Repeat the Self-
Clean steps from the beginning,
being
certain
to close the door completely.
Do
not try to force the door open after it is
locked, as the automatic latch can be
damaged.
If you need to unlock
the door,
turn off the Self-Clean
cycle by pressing
the
"CANCEL.SECURE"
pad. After approximately
1 minute,
"LOCK"
will disappear
from the
clock display, and the door will unlock.
The door will remain
locked
until the oven
temperature
falls below 390°F, Do not select
any cooking function
until the oven door is
unlocked,
8.
About 50 to 60 minutes will be required
for the oven to reach the Self-Clean
temperature of 850°F.
9.
The Self-Clean cycle can be stopped at
any time by pressing "CANCEL,SECURE"
10. After completion of the Self-Clean cycle,
the oven will stop heating and the "ON"
and "CLEAN" indicators will disappear
from the clock display. Press the
"CANCEL,SECURE"
pad.
11. After the interior oven temperature
falls
below 390°F, the door latch will release
and "LOCK" will disappear from the clock
display. The door can now be opened.
12.
Open the door. After ensuring that the
oven has cooled sufficiently to be safe, use
a damp cloth or sponge to wipe out the
powder residue found in the bottom of the
oven. If white spots remain in the oven,
remove them with a non-scratch
scouring
pad before using the oven again. These
spots are normally salt that cannot be
removed by a Self-Clean cycle.
13.
Re-install the oven racks and convection
fan filter before cooking in the oven.
.I--IN
.UU
CLEAN
LOCK
ON
CLEAN
TIME
Clock Display in Self-Cleaning
Mode
_
IMPORTANT:
With the oven at room temperature,
if the
Self-Clean
mode is accidentally
selected
and
the oven enters
Self-Clean
mode (indicated
by "LOCK"
and "ON"
in the clock display),
the user must cancel
out of this mode before
attempting
to select a different
mode. To
cancel,
press the "CANCEL.SECURE"
pad.
Wait at least 60 seconds
before attempting
to
select another
mode. This
allows
the door
latch time to unlock.
SELF-CLEANING
TIPS:
1
If any soil remains in the oven after
completion of a Self-Cleaning
cycle, repeat
the cycle if desired. Increase the cleaning
time during future cycles.
2.
Clean the oven regularly to prevent
excessive soil build-up. This will increase
the efficiency of the Self-Clean cycle and
reduce the amount of smoke and odors
generated.
3.
Self-Clean in the cooler evening hours after
cooking is complete
and when electricity
rates are lower.
4.
In the double oven, if one oven is in
the Self-Clean mode the other oven is
inoperable.
II Adjusting
the Oven Temperature
i
_
IMPORTANT:
The user may find the temperature
in their
new oven to be different
from that of their
previously-owned
appliance.
Familiarity
with the old appliance
sometimes
makes
it
difficult
to get used to a new oven. If you feel
that the oven temperature
is consistently
high or low, the temperature
of the new oven
can be adjusted.
The adjustment
needs to be
done only once.
The oven temperature
may be adjusted
(calibrated)
by following
these steps:
1.
Press "BAKE" selector pad
2.
Press the "TIME.TEMP"
"+" pad to set a
temperature
of 500°F or higher.
3.
Press and hold the "BAKE" selector
pad. After approximately
5 seconds the
temperature
display is replaced by "00".
The "BAKE" pad can now be released. The
calibration mode has been accessed.
4.
Press the "TIME.TEMP"
"+" or "-" pad to
set the amount of temperature
adjustment.
The temperature
can be changed a
maximum of 35°F higher or lower. Set
the adjustment to positive (+) numbers
to increase the oven temperature;
set
the adjustment to negative (-) numbers
to reduce the oven temperature.
Temperatures
can be adjusted in
increments of 5°F.
5.
After setting the desired temperature
adjustment,
press the "CANCEL.SECURE"
pad to exit the calibration mode and to
reset the clock display.
2, .NN .UU
CLEANt_K
ON
CLEAN
TIME
oLoo. II s.o..o0
II- q
Clock Display
When Adjusting
(Calibrating)
the Oven
Temperature
_
NOTES:
1.
If "CANCEL,SECURE"
is not pressed
after setting
the adjustment,
the clock
display will automatically
reset in 6
seconds.
2.
The amount of temperature
adjustment
may be changed again by repeating
the calibration
procedure. The oven
will only retain the amount of the most
recent temperature
adjustment.
3.
The temperature
adjustment
is not
affected by an electrical power failure
4.
The temperature
adjustment
only
affects Standard Bake and Convection
Bake modes, Broil and Self-Clean
temperatures
cannot be adjusted.
Hide quick links:
Advertisement
Table of Contents
