Cisco PVDM2 24DM - Digital Modem Module User Manual page 13

Cisco PVDM2-12DM, PVDM2-24DM, and PVDM2-36DM Digital Modem Packet Voice Data Modules
DETAILED STEPS
Command or Action
Step 1
modem recovery threshold failed-calls
Example:
Router(config)# modem recovery threshold 10
Step 2
modem recovery action {disable | none}
Example:
Router(config)# modem action recovery disable
Example
The following configuration will result in a modem being marked bad by the IOS after 8 consecutive
failures.
router(config)# modem recovery threshold 8
router(config)# modem recovery action disable
Loading Modem Firmware
To load a different version of CSM V12 firmware into the digital modem PVDM2s, use the
modem firmware command in global configuration mode.
Note It may take two to four minutes for the new version to appear.
SUMMARY STEPS
1.
2.
3.
configure terminal
modem firmware slot slot-number location ifsfilename
exit
How to Configure Digital Modem PVDM2s
Purpose
Specifies the number of consecutive failure that
must occur on a modem before modem recovery
action takes place.
The range is 0 to 1000. The default value is 30.
Specifies the action to be taken on a modem when its
modem recovery threshold is reached. disable will
cause the IOS to mark the modem as bad and remove
it from service. none will reset the threshold counter
for the modem, but will do nothing else. The modem
stays in service.
Cisco IOS Release 12.4(9)T, 12.4(11)XW, and 12.4(20)T
13