Yamaha CVP-309PE Owner's Manual page 210

4
Attach the rear leg.
1 Fix the rear legs to
the bottom surface
of the unit using
two screws.
If the screw holes do not align, loosen the other screws and
adjust the position of the rear legs.
5
Raising the unit to the standing position.
Use the front legs as support to raise the unit.
CAUTION
• Be careful not to pinch your fingers.
• When you raise the unit, do not hold the key cover.
6
Installing the pedal box.
1 Remove the
plastic cover from
the rear legs.
4 Make sure that the pedal box lays flat, with no
gap between itself and the floor, then affix the
pedal box using two screws.
210 CVP-309/307 Owner's Manual
2 Fix the rear legs to the
speaker box using two
screws.
2 Untie and straighten
out the bundled
cord attached to the
bottom of the pedal
box.
3 Pass the pedal
cord between
the pedal box
and the rear leg.
7
Connect the pedal cord.
arrow-printed side facing front
(toward the keyboard side).
If the plug will not go in easily,
do not force it. Double-check
the orientation of the plug,
then try again.
2 Align the pedal cord into
Correct
Incorrect
8
Set the voltage selector and connect the power
cord.
240
127
Voltage Selector
Before connecting the AC power cord, check the setting of the
voltage selector which is provided in some areas. To set the selec-
tor for 110V, 127V, 220V or 240V main voltages, use a "minus"
screwdriver to rotate the selector dial so that the correct voltage
for your region appears next to the pointer on the panel. The volt-
age selector is set at 240V when the unit is initially shipped.
After the proper voltage has been selected, connect the AC
power cord to the AC INLET and an AC wall outlet. A plug adap-
tor may be also provided in some areas to match the pin config-
uration of the AC wall outlets in your area.
WARNING
An improper voltage setting can cause serious damage to
the Clavinova or result in improper operation.
1 Insert the
pedal cord
plug into the
pedal connec-
tor.
Insert the plug
with the
the groove on the rear leg,
and install the plastic cover
onto the groove. Be careful
not to insert the cover's
attachment strip between
the groove wall and the leg.
(the bottom of the right side
as seen from the front)