Advertisement
STEP 8:
(SEE FIGURE 8)
*
Push on flow control arm until it locks in "OFF"
position.
*
Slide flow control mounting bracket along tube until
closure plate in bottom of hopper just closes.
*
Snug the 5/16" nylock hex nuts just enough to
*
hold flow control mounting bracket in place.
*
Set adjustable stop at "5". Pull flow control arm
against stop. Verify that closure plate has opened
about half way.
*
if closure plate does not open half way, adjust position
of flow control mounting bracket until closure plate will
open about half way at "5" and will still close when
arm is locked in "OFF" position. Tighten the 5/16"
nylock hex nuts.
FLOW
CONTROL
ARM
ADJ USTABLE
STOP
(SETTING "5")
FIGURE 8
STEP 9:
(SEE FIGURE 9)
*
Place screen down into hopper, sliding edge of
screen under one of the clips. Slightly bow the screen
to slide opposite side of the screen under other clip.
©
FIGURE 9
CLIPS
STEP 10:
(SEE FIGURE 10)
*
For most vehicles, you can keep the assembled hitch
extension bracket in its default position shown in
figure 10. Attach the spreader hitch to your vehicle
hitch. Check for interference with the spreader directly
behind and out to both sides of the vehicle. Lift the
spreader at each position to make sure there is no
interference with the spreader's flow control, if there
is interference with the rear of the vehicle, assemble
the hitch extension bracket as shown at the bottom
of figure 10. Tighten bolts and nuts when finished.
DEFAULT POSITION
EXTENDED
(IF INTERFERENCE)
6
FIGURE 10
Call 1-868-578-8388
for missing parts or assembly help
DO NOT RETURN TO STORE
Advertisement
