Kenmore 8751 - 6.7 cu. Ft. HE2 Electric Dryer Use And Care Manual page 24

2. Place dryer rack inside dryer drum, positioning the back wire
on the ledge of the inner dryer back panel. Push down on
front edge of dryer rack to secure over the lint screen.
A
A. Dryer rack front edge
B. Dryer back panel
3. Put the wet items on top of the rack. Leave space between
the items so air can reach all the surfaces.
NOTE: Do not allow items to hang over the edge of the rack.
4.
5.
6.
Close the door.
Press the POWER button.
Select a timed cycle and temperature (see following chart).
Items containing foam, rubber, or plastic must be dried on a
clothesline or by using the Air Only temperature setting.
7. You may change the cycle time by pressing MORE TIME or
LESS TIME. Reset time as needed to complete drying. Refer
to the following table.
8. Press (and hold) START button (about 3 seconds).
NOTE: You must remove rack for normal tumbling. Do not use
automatic cycles with the dryer rack.
This chart shows examples of items that can be rack dried and
the suggested temperature setting and drying time. Actual drying
time will depend on the amount of moisture items hold.
Rack Dry Setting Temp. Time*
Wool Sweaters Timed Low 60
Block to shape and lay fiat on Cycles
the rack.
Stuffed toys or pillows Timed Low 60
Cotton or polyester fiber filled cycles
Stuffed toys or pillows Timed Air Only 90
Foam rubber filled cycles (no
heat)
Sneakers or canvas shoes Timed Air Only 90
cycles (no
heat)
*(Minutes) Reset time to complete drying, if needed.
24