Kenmore 8751 - 6.7 cu. Ft. HE2 Electric Dryer Use And Care Manual page 17

You can change your door swing from a right-side opening to a
left-side opening, if desired.
1. Place a towel or soft cloth on top of the dryer or work space
to protect the surface,
Remove the door assembly
1. Remove the 4 screws that hold the door hinge on the front
panel of the dryer.
Reverse hinge
1. Use a small flat-blade screwdriver to remove 2 plug strips
from the inner door. Slide the head of the screwdriver under
the plugs, being certain not to scratch the inner door surface,
Lift up.
®
A. Dryer front panel
B. Door assembly
2.
3.
Lay the door assembly on a flat, protected surface with the
inside (inner door assembly) facing up.
Remove the 6 Phillips head screws to release the outer door
assembly from the inner door assembly, as indicated below.
See illustration, It is important that you remove only the
6 indicated screws,
o J
4. Lift the inner door assembly off the outer door assembly,
5. Rotate outer door 180 °.
180 °
2.
Remove the 4 screws that attach to the inner door hinge and
move the hinge to the other side. Reinstall the 4 screws.
A. Door hinge
3. Reinstall plug strips on opposite side of the inner door.
4. Check for fingerprints on the glass. Clean glass if necessary.
5. Place the inner door assembly inside the outer door
assembly. To fit correctly, the inner door assembly edge fits
completely inside the outer door assembly edge.
6. Reassemble the inner and outer door assemblies with the
6 screws,
17