Ricoh AP610N - Aficio B/W Laser Printer Maintenance Manual page 61

Messages/Second
messages
P= XX I= XXXXXXXX A controller error. The SC
number indicates the problem.
Power Off On
/ If Error Reoccur
Call Service
Processing... Print data is being processed.
RC Gate Cannot communicate with RC
Gate.
connection error
Ready The default ready message. The
printer is ready to use.
Remove Misfeed There is misfeed in the Duplex
Unit.
Duplex Unit
/ Open Duplex
Unit Cover
Remove Misfeed There is a misfeed in the printer. Remove the misfed paper.
Internal Path
/ Open
Front Cover
Remove Misfeed There is a misfeed in the paper
exit cover.
Paper Exit Cover
/ Open Paper
Exit Cover
Remove Misfeed Paper is jammed in the speci-
fied input paper tray.
Paper Tray
/ Pull out Tray
Remove Paper The standard tray is full, and
the print job is suspended.
Standard Tray
Replace It is time to replace the mainte-
nance kit (friction pad, paper
Maintenance Kit
feed roller, transfer roller and
fusing Unit).
Replace The toner cartridge is not set
correctly or toner is almost run
Toner Cartridge
out.
The toner dust is full.
Reset Duplex A communication error sent
from the system unit to the du-
Unit correctly
plex unit.
Error & Status Messages on the Control Panel
Description Solution
Turn the power off, and then on. If the
message appears again, call your sales
or service representative.
Wait a while.
Check the device or the RC Gate net-
work connection.
No action required.
Remove the misfed paper.
See p.76 "When "Remove Misfeed
Duplex Unit" Appears".
See p.71 "When "Remove Misfeed In-
ternal Path" Appears".
Remove the misfed paper.
See p.73 "When "Remove Misfeed Pa-
per Exit Cover" Appears".
Remove the misfed paper.
See p.70 "When "Remove Misfeed Pa-
per Tray" Appears".
Remove paper from the standard tray,
and the print job will be resumed au-
tomatically.
Replace the new maintenance kit.
See p.32 "Replacing the Maintenance
Kit".
Set the toner cartridge correctly.
See p.29 "Replacing the Toner Car-
tridge".
Prepare a new toner cartridge. If the
image density gets too light, replace
the toner cartridge with a new one.
See p.29 "Replacing the Toner Car-
tridge".
Set the duplex unit correctly. If the
problem persists, call your service
provider.
5
57