Ricoh AP610N - Aficio B/W Laser Printer Maintenance Manual page 58

Troubleshooting
Messages/Second
messages
Hardware Problem
Ethernet
Hardware Problem
HDD
5
Hardware Problem
IEEE1394
54
Description
An error has occurred in the
optional Network Interface
Board.
An error has occurred in the
optional Hard Disk Drive.
The printer identified an IEEE
1394 interface board error.
Solution
Turn the power off, and then on. If the
message appears again, call your sales
or service representative.
Turn the power off, and then on, If the
message appears again, call your sales
or service representative.
Turn off the power. Replace the Hard
Disk Drive and turn on the power.
See "Attaching Hard Disk Drive Type
2600 ", Setup Guide.
Turn off the power. Remove the Hard
Disk Drive and turn on the power.
Note
❒ If the Hard Disk Drive is not in-
stalled, you cannot send the sam-
ple print job, locked print job and
download the font to Hard Disk
Drive using the PS Utility for Mac.
Turn the power off, and then on.
Remove and re-install the IEEE 1394
interface board correctly.
A
Check the IEEE 1394 interface
board is correctly attached to the
computer.
B
Check the IEEE 1394 interface ca-
ble is securely connected.
C
Unplug the IEEE 1394 interface cable
which is connected to the printer.
D
Restart the computer. If the mes-
sage appears even after executing
above operation, proceed to the
following steps.
E
Execute the utility tool for IEEE
1394 interface board that is stored
in the following path in the CD-
ROM labeled "Printer Drivers and
Utilities": UTILITY\ 1394
Important
❒ For details about using the utility
tool for IEEE 1394, see the RE-
ADME file in the same directory in
the CD-ROM. If the message ap-
pears again, contact your sales or
service representative.
See "Attaching 1394 Interface Unit
Type 4510", Setup Guide.