Ricoh AP610N - Aficio B/W Laser Printer Maintenance Manual page 59

Messages/Second
messages
Hardware Problem The printer identified an op-
tional RAM error.
Option RAM
Hardware Problem There is a problem with the
parallel interface.
Parallel I/F
Hardware Problem There is a problem related to
the Universal Serial Bus Con-
USB
nection and Hardware.
Hardware Problem An error was detected in the
IEEE 802.11b interface unit or
Wireless Board
the Bluetooth interface unit.
Hardware Problem The IEEE 802.11b interface unit or
the Bluetooth interface unit could
Wireless Card
not be detected when the power
was turned on. The IEEE 802.11b
interface card or the Bluetooth in-
terface card was removed after
the power was turned on. An er-
ror was detected in the IEEE
802.11b interface card or the Blue-
tooth interface card.
HDD Full The maximum HDD area size for
form/font has been exceeded.
The optional Hard Disk Drive is
full. The sample print job or
locked print job to be sent from
the computer is too large to store.
Error & Status Messages on the Control Panel
Description Solution
Turn the power off, and then on. Re-
move and re-install the optional RAM.
If the message appears again, contact
your sales or service representative.
See "Attaching Memory Unit Type C
256MB (SDRAM Module)", Setup
Guide.
Turn off the power, remove the mem-
ory unit, and then turn on the power.
Note
❒ If you remove the memory unit,
you must set up the option with
the printer driver.
❒ In this case, you might not be able
to print complex print jobs.
If you use the parallel I/F, replace the
interface cable that caused the error. If
the message appears again, contact
your sales or service representative.
Turn the power off, and then on. If the
message appears again, contact your
sales or service representative.
Turn the power off, and then on. Re-
move and re-install the IEEE 802.11b
interface unit or the Bluetooth inter-
face unit correctly.
If the message appears again, contact
your sales or service representative.
See " Attaching 802.11b Interface Unit
Type F " or "Attaching Bluetooth In-
terface Unit Type C ", Setup Guide.
Turn the power off, and then on. Re-
move and re-install the IEEE 802.11b
interface unit or the Bluetooth inter-
face unit correctly.
If the message appears again, contact
your sales or service representative.
See " Attaching 802.11b Interface Unit
Type F " or "Attaching Bluetooth In-
terface Unit Type C ", Setup Guide.
Delete the disused form/font types.
Delete any unnecessary stored files.
5
55