AUDITING ACCOUNTS
If this copier has been programmed in the auditing mode, it will not function
until an assigned 3-digit account number has been entered. See page 40 for
setting the auditing mode.
If the copier has been programmed in the auditing mode, "– – –" will appear
in the copy quantity display in the initial conditions.
1
Enter your account number using the numeric keys.
As each digit is entered, the dashes in the copy quantity display will
●
disappear.
After the number is entered, the copy quantity display will change to
●
0.
If an unassigned number is entered, "– – –" will appear again in the
●
copy quantity display, indicating that the number was not accepted.
2
When copying is completed, press the AUDIT CLEAR
key.
"– – –" will appear again in the copy quantity display, indicating the
●
auditing mode.
In the interrupt copy mode (see page 25), press the INTERRUPT key
●
after an interrupt copy run is completed. All previous copier settings
will be restored and the previous account number will be active.
13