Advertisement
AIR FLOW
This button is used to change the
direction of the air
flow.
The air flow choices available
are WINDSHIELD, MID and FLOOR.
If
the system is
set for AUTO, pressing the AIR FLOW button will
display the current air flow direction. Press the AIR
FLOW up or down arrows again to change the direction
of the air
flow.
If the up AIR FLOW button is selected while in the
FRONT defrost mode, the system will direct the air
toward the floor and the windshield. If the down AIR
FLOW button is selected while in the FRONT defrost
mode, the system will send the air toward the FLOOR,
and FRONT will cancel. Notice the arrows in the
display.
VENT The VENT button allows fresh air to flow
through your Buick without the air conditioning
compressor working. AUTO and VENT may be selected
at the same time so the system will continue to maintain
the temperature selected.
To turn off the VENT selection
push the button again.
RECIRC: When RECIRC is selected, the system will
limit the amount of fresh air entering your vehicle. This
is helpful when you are trying to cool the air quickly or
limit the amount of air entering your vehicle for some
other reason. If the system was previously in AUTO,
RECIRC can be selected. The system will be in
RECIRC for 10 minutes, then remain in AUTO but
return to the EXT temperature display. RECIRC can
also be selected in manual air flow positions.
FRONT
FRONT This selection
is used to defrost the
windshield by directing the
air flow toward the
windshield.
If FRONT is selected while in the AUTO mode, the fan
speed will vary. If a manual fan speed setting is selected,
the fan speed will remain at that selection until the
engine is turned off or another selection has been made.
To turn off FRONT, press AUTO or AIR FLOW.
FRONT defrost will work better if any ice or snow is
cleared from
the
hood and the air inlet area between the
hood and windshield.
3-4
Advertisement
