Advertisement
If the display is flashing after the system is started, you
should see your dealer for service.
Sun and temperature sensors automatically adjust air
temperature to maintain your temperature setting. The
system may supply cooler air
to
the side towards the
sun. Be careful not to put anything over the sensors on
top of the dash. The system may not respond correctly.
AUTO: Press the AUTO button when you want the
system to adjust automatically to changes in
temperature. When the system is set for automatic, air
will come from the floor, middle, or windshield outlets.
Fan speed will vary as the system gets to and maintains
the temperature setting you have selected.
To find your comfort zone, start with 75" AUTO, give
the car about 20 minutes to stabilize, and adjust the
temperature setting if necessary. The display will show
the set temperature and fan speed for a few seconds and
then display the outside temperature. If you want to
check and see what automatic temperature setting has
been chosen, press the AUTO button.
In cold weather the system will delay turning on the fan,
to
avoid blowing cold air. The length of the delay
depends on engine coolant temperature, outside
temperature, and time since the engine was last started.
Pushing the FAN, AIR FLOW or FRONT buttons will
override this delay, turn off the AUTO setting, and
change the Fan speed.
TEMP: To adjust the temperature you want maintained
inside the car, push the TEMP button. If you want warmer
air push the red arrow. If you want cooler air push the blue
arrow. Note the degree selection in the display.
You can choose between 60°F (16°C) for maximum
cooling, to 90°F (33°C) for maximum heating. The
system does not cool or warm faster with 60°F (16°C)
or
90°F (33°C) selected, so
it
is not necessary to choose
the extreme temperature to get the system to heat or cool
at the maximum. The system does
it
automatically.
FAN: The speed of the blower fan is controlled
automatically if you have the system set for AUTO.
Pressing the FAN button will display and hold the
current blower fan setting.
If you want the blower fan to run at a lower speed, push
the bottom of the FAN button. The fan speed will
decrease with every push of the button until the lowest
speed is reached. If you want to increase the fan speed,
push the top of the fan button. Notice the fan indicators
in the display.
3-3
Advertisement
