Start or Stop vShield Edge Services
You can start and stop the VPN, DHCP, and load balancing services of a vShield Edge from the vSphere Client.
By default, all services are stopped, or in Not Configured state.
N
You should configure a service before starting it.
OTE
To manage services on a vShield Edge
1
In the vSphere Client, go to Inventory > Networking.
2
Select an internal port group that is protected by a vShield Edge.
3
Click the vShield Edge tab.
4
Click the Status link.
5
Under Edge Services, select a service and click Start to start the service.
Select a service and click Stop to stop a running service.
6
If a service has been started but is not responding, click Refresh Status to send a synchronization request
from the vShield Manager. to the vShield Edge.
VMware, Inc.
Chapter 10 vShield Edge Management
59