Start Or Stop Vshield Edge Services; Upgrade Vshield Edge Software - VMware VSHIELD APP 1.0.0 UPDATE 1 Admin Manual

vShield Administration Guide
15 Press ENTER.
You can add additional web servers in the same manner.
16 Click Commit.
17 If load balancer service has not been enabled, enable the service.
See

"Start or Stop vShield Edge Services"

Start or Stop vShield Edge Services
You can start and stop the VPN, DHCP, and load balancing services of a vShield Edge from the vSphere Client.
By default, all services are stopped, or in Not Configured state.
N You should configure a service before starting it.
OTE
To manage services on a vShield Edge
1 In the vSphere Client, go to Inventory > Networking.
2 Select an internal port group that is protected by a vShield Edge.
3 Click the vShield Edge tab.
4 Click the Status link.
5 Under Edge Services, select a service and click Start to start the service.
Select a service and click Stop to stop a running service.
6 If a service has been started but is not responding, click Refresh Status to send a synchronization request
from the vShield Manager. to the vShield Edge.

Upgrade vShield Edge Software

You upgrade the vShield Edge software on a per vShield Edge basis. vShield Edge upgrades must be
performed separately from vShield Manager-based upgrades.
To upgrade vShield Edge software
1 In the vSphere Client, go to Inventory > Networking.
2 Select an internal port group that is protected by a vShield Edge.
3 Click the vShield Edge tab.
4 Click the Status link.
5 To the right of the Configuration heading, determine if there is a new version to the right of the Upgrade
to link.
6 Click Upgrade to to locate and install the upgrade file.
56
on page 56.
VMware, Inc.