Assembly - KitchenAid STAND MIXER K5SS Instructions And Recipes Manual

Assembling Your 5 Quart Mixer
TO ATTACH BOWL
1. Be sure speed control is OFF and
mixer is unplugged.
2. Place bowl lift handle in down
position.
3. Fit bowl supports over locating pins.
4. Press down on back of bowl until
bowl pin snaps into spring latch.
5. Raise bowl before mixing.
6. Plug mixer in proper electrical outlet.
TO REMOVE BOWL
1. Be sure speed control is OFF and
mixer is unplugged.
2. Place bowl lift handle in down
position
3. Remove flat beater, wire whip, or
dough hook.
4. Grasp bowl handle and lift straight
up and off locating pins.
TO RAISE BOWL
1. Rotate handle to straight-up position.
2. Bowl must always be in raised,
locked position when mixing.
TO LOWER BOWL
1. Rotate handle back and down.
WARNING
!
Injury Hazard
Unplug mixer before inserting
or removing beaters.
Unplug mixer before cleaning.
Failure to do so can result in
broken bones or cuts.
TO ATTACH FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
1. Turn speed control to OFF and
unplug.
2. Slip flat beater on beater shaft and
press upward as far as possible.
3. Turn beater to
right, hooking
beater over the
pin on shaft.
**
4. Plug mixer in proper electrical outlet.
TO REMOVE FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
1. Turn speed control to OFF and
unplug.
2. Press beater upward as far as
possible and turn left.
3. Pull beater from beater shaft.
4. Plug mixer in proper electrical outlet.
HOUSEHOLD MIXER
SPEED CONTROL
RAISE
Plug mixer in proper electrical outlet.
Speed control lever should always to be
set on lowest speed for starting, then
gradually moved to desired higher speed
to avoid splashing ingredients out of bowl.
See pages 14, 18 for Speed Control Guide.
OVERLOAD RESET BUTTON
will pop out and the mixer will shut off.
Turn the Speed Control Lever to OFF.
Wait a few minutes, then push in the
Reset Button. Turn the Speed Control
Lever to the desired speed and continue
mixing.
** See page 6.
9
Models KSM50P and
KSMC50 only
If the mixer is overloaded,
the Overload Reset Button
PIN
**
**
**