Speed Control Guide; Product Assembly - KitchenAid 5KSM3310X Owner's Manual

SPEED CONTROL GUIDE

All speeds have the Soft Start feature, which automatically starts the Stand Mixer at a lower
speed to help avoid ingredient splash-out and "flour puff" at start-up, then quickly increases to
the selected speed for optimal performance.
SPEED
1/2
1
2
4
6
8
10
NOTE: The speed control can be set to obtain speeds 1, 3, 5, 7, and 9 if a finer adjustment is
required. Do not exceed Speed 2 when preparing yeast doughs as this may cause damage to
the Stand Mixer.
NOTE: Refer to "Product Usage" section for maximum advised quantities per Food Type.

PRODUCT ASSEMBLY

1.
Turn the Stand Mixer to OFF (0) and unplug.
2.
Unlock and lift the Motor Head. Then, lock
3.
Place the Bowl on the Clamping Plate and twist clockwise to lock in place.
4.
With the Motor Head lifted and locked, slide the accessory over the shaft, aligning with the
pin, then rotate clockwise to hook it over the pin on the shaft.
5.
Unlock the Motor Head and move it down. Then, lock
mixing, test lock
(OPTIONAL) To Adjust beater to Bowl Clearance: Tilt and lock
Locate the screw revealed under the Motor Head. Turn the screw slightly counterclockwise
(left) to raise the beater, or clockwise (right) to lower it.
NOTE: When properly adjusted, the Flat Beater will not strike on the bottom or side of the
Bowl. If the Flat Beater or the Wire Whip is so close that it strikes the bottom of the Bowl,
the beater or Whip may wear.
NOTE: If you over-adjust the screw, the bowl lock lever may not lock into place.
*Accessory sold separately.
**Locking option is available on select models.
ACCESSORIES
Flat Beater
Flex Edge Beater
Flat Beater
Dough Hook
Flex Edge Beater
Wire Whip
Flat Beater
Wire Whip
Wire Whip
Wire Whip
** by attempting to raise the Motor Head.
*
*
** the head to keep it lifted.
** the head to keep it down. Before
ACTION
Stir
Slow mixing
Mixing,
beating
Beating, creaming
Fast beating,
whipping
Fast whipping
** the Motor Head back.
5