Backlight Operation; Reader Configuration; Power On Beep Codes - ACT PRO MIFARE CLASSIC READERS Operating And Installation Instructions

Hide thumbs

Table Of Contents

Table of Contents

ACTpro MIFARE classic Operating and Installation Manual

The ACTpro MIFARE 1050 has backlight illumination of the keypad. The default operation is for the illumination to be

switched on all the time. During installation the back light operation may be switched off or changed to automatic. In

automatic mode the keypad is illuminated for 20 seconds on a key press or when a card is presented to the reader.

To change the backlight operation: Firstly power up the reader, the LED on the top right hand side will cycle through

green, blue and red and back to blue, while the LED is red enter the code below for the required operation. The code

must be completely entered while the LED is red.

•Always on (Default):X014000

•Always Off:X014001

•Automatic:X014008

Note: the backlight operation for the ACTpro MIFARE 1030PM is controlled by jumpers marked LED.

The Internal buzzer is activated by applying 0V to the Buzz PIN. The buzzer activates 4 seconds after the 0V is

applied and sounds continuously until the 0V is removed (External Buzzer Control not available on the ACTpro

MIFARE 1030) reader.

The Red and Green LED are activated by applying 0V to the respective Red and Green input pins.

The Output Data Format and the Sector/Serial Operation of the reader can be determined by the beeps generated

by the reader after power is applied. The reader will generate two sets of beeps, the first indicating the Output Data

Format and the second set of beeps indicating Sector or Serial Operation. The first set of beeps will occur while the

LED is Green, the second set of beeps occur half a second later while the LED is Blue.

First Beep Set

Second Beep Set

Note: If the reader has been re-programmed (see next page), then a series of notes is played after the Second Beep

Set, this indicates that the default programming to read ACT MIFARE cards has been changed.