ACT ACT5 DIGITAL KEYPAD Installation Notes

place. in LK1 without
programming.
forgotten.
mode) programming exits Keypad
inactive.
indicator red the time, this During
will keypad The row. a in entered
set} timer — stops {Buzzer
period} required wait
timing... indicating sounds {Buzzer
Time)
=1234, 1 User 9999, =
user) deletes 0000
code) programming = ü
exited. is mode programming
any at pressed is X If . mode programming
The 9999) all (initially code engineering
Programming
INSTALLATION NOTES
Always remember to factory default the controller before
you start programming.
Always remember to place the supplied Varistor
across the terminals of the door strike coil to protect
the relay contacts.
Never use the onboard relay to switch AC mains voltage.
An external relay isolated electrically from the ACT5
should be used for this purpose.
Don't forget to change the programming code to some-
thing known only to yourself.
IMPORTANT
As with any access control system, always ensure that there is
an alternate means of escape in the event of the unit failing to
operate due to power loss or in the event of fire.
Unit 8, IDA Business Park,
Whitestown, Dublin Ireland.
Tel: 353-1-4622585 Fax: 353-1-4622587,
Copyright 2003 Access Control Technology Ltd.
For full details on the ACT product range and a list of distributors,
Visit our website www.accesscontrol.ie
correctly operate not will keypad
with proceed and power Restore
again. power Remove
LK1. link Replace
unit. to power Apply
LK1. link Remove
unit. the from power the Remove
been has code programming
& Restored Defaults (Factory
Mode) Programming
Defaults Factory Restoring
be will coded user all and flash
seconds. 20 for mode lockout
been have codes invalid three When
Lockout Code
timing) (Stop
Timer) (Relay
active Relay (Set
mode) programming
time: active Relay the
inactive. others
Programming : codes user Default
– code digit (4 0000-9999
0-9, number (user ü 0-9,
codes) (Change
mode) programming
Codes: Changing
seconds, 30 within pressed is key
in while Amber flash
the by followed button X
mode: programming
Keypad Digital ACT5
(18-00001-27)
The Note:
6.
5.
4.
3.
2.
1.
pro-
the If
üüü
factory
(From
will
enter
Incorrect
ü
period
for
0
2 Enter
(from
Setting
program-
All
code
0 Enter
(from
programming
no or time
will LED
the Press
enter To
GUIDE
Downloaded from: http://www.guardianalarms.net
the pressing and
ü
the entering by time any
its to returned be may
use. normal for ready now
Red. be will LED The button.
Mode. Programming
timer. relay the into programmed
this – stop to Press period.
ü
sound to buzzer the Allow
Time Active Relay
.
digits).
new the by followed
Code. Programming
1 user new the by followed
code. 1
Amber flash
the by followed
Mode. Programming
system) typical
PROGRAMMING
ACT5 DIGITAL KEYPAD
times. three
mode gramming
at condition default
keypad The Note:
is keypad The
X the Press
Exit
5.
now is
desired the
0. then 2, Press
Desired Set
4.
(four code ming
ü then 0, Press
Change 3.
digits) (four
1 then 0, Press
User Change 2.
will LED The
(9999) code
button X Press
Enter 1.
(for
SECOND 30