Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ACT ACT 10 DIGITAL KEYPAD
Summary of Contents for ACT ACT 10 DIGITAL KEYPAD
- Page 1 ACT 10 Digital Keypad Operating & Installation Instructions 18-00001...
-
Page 2: Product Specification
ACT 10 Digital Keypad Operating & Installation Instructions Installation Notes Important Product Specification Ordering Information... -
Page 3: For Door 2 Operation
ACT 10 Digital Keypad Operating & Installation Instructions 30 Second Programming Guide yellow / , then press 1 For Door 2 Operation ACT 10 Digital Keypad Programming... -
Page 4: Changing Codes
ACT 10 Digital Keypad Operating & Installation Instructions Changing Codes: Enter Programming Mode, then Press Setting Switched Output Combinations: Enter Programming Mode, then Press Setting Timers: Enter Programming Mode, then Press... -
Page 5: Setting Configuration
ACT 10 Digital Keypad Operating & Installation Instructions Setting Configuration: Enter Programming Mode, then Press... -
Page 6: Restoring Factory Defaults
(e.g. magnetic lock). lock (e.g. magnetic lock) Door Release Button for Door 2 The ACT 10 may be used to control 2 doors as illustrated in the diagram above Break Glass Door 2 Unit (optional) Shows connection for normally ENERGISED... - Page 7 3 Outputs (100mA) Tamper 3 Inputs (100mA) Figure 3: ACT 10 Digital Keypad - Guide to outdoor installation in exposed areas EXIT Figure 2: ACT10 Digital Keypad_Guide to outdoor installation in exposed areas silcone all screw mounting positions and cable entry.
- Page 8 Installation Instructions for ACT 10 Flush Mount Kit User List User User Name Door 1 Door 2 This manual and user list is available for download from our website, www.accesscontrol.ie © Copyright 2007 Access Control Technology Ltd.
Need help?
Do you have a question about the ACT 10 DIGITAL KEYPAD and is the answer not in the manual?
Questions and answers
we have been changing the code on the device but the old keycode seems to be working .where have we gone wrong ?
The old keycode may still be working on the ACT 10 Digital Keypad after changing it due to one of the following reasons:
1. Programming Mode Not Exited Properly – If the programming mode was not exited correctly (by pressing the exit button or waiting for 30 seconds of inactivity), the changes may not have been saved.
2. Incorrect Code Change Process – If the steps to change the user code were not followed correctly, the new code may not have been assigned properly.
3. User Code Not Assigned to a Door – If the new code was entered but not assigned to a door, the system may still recognize the old code as valid.
4. Factory Default Not Applied – If the keypad was previously used and not factory reset before reprogramming, old codes may still be stored.
To resolve the issue, verify the code change steps, ensure proper assignment to a door, exit programming mode correctly, and factory reset if necessary.
This answer is automatically generated