• Never use the onboard relay to switch AC mains voltage. An external relay isolated electrically from the ACT 10 should be used for this purpose. • Don’t forget to change the programming code to something known only to yourself.
The ACT 10 Digital Keypad is now ready for normal use. Note: The ACT 10 Digital Keypad may be returned to its factory default condition at any time by entering the programming mode and pressing the button three times .
ACT 10 Digital Keypad Operating & Installation Instructions Enter Programming Mode, then Press Setting Configuration: Step Keypad Entry Operation 30-37 or 40-47 option number 1= Set, 0 = Unset 0 or 1 Option Function Default Operation Door Chime When set, whenever the door contact is opened, the built-in buzzer makes a chime sound and the buzzer output activates for 2 seconds.
(e.g. magnetic lock). lock (e.g. magnetic lock) Door Release Button for Door 2 The ACT 10 may be used to control 2 doors as illustrated in the diagram above Break Glass Door 2 Unit (optional) Shows connection for normally ENERGISED...
Page 7
3 Outputs (100mA) Tamper 3 Inputs (100mA) Figure 3: ACT 10 Digital Keypad - Guide to outdoor installation in exposed areas EXIT Figure 2: ACT10 Digital Keypad_Guide to outdoor installation in exposed areas silcone all screw mounting positions and cable entry.
Page 8
Ensure that the cable comes through the cable entry in the back box • Remove back plate from the ACT 10 and mount on to the removable cradle with the 3 bolts provided again bringing the cable through the rear cable entry in the back plate •...