ACT ACT10 DIGITAL KEYPAD Installation Notes

sheet. this of side other
complete the to refer
advanced the programming
times. three the pressing
%
pro- the entering by
factory its to returned
use. normal for
should LED yellow
Mode.
timer. relay the into
pe- this – stop to %
for sound to buzzer
. Time Active
program- new the by
Code.
code 1 user new the by
flashing be should
programming the by
Mode.
system)
GUIDE PROGRAMMING
INSTALLATION NOTES
Always remember to factory default the controller before
you start programming.
Always remember to place the supplied Varistor
across the terminals of the door strike coil to protect
the relay contacts.
Never use the onboard relay to switch AC mains voltage.
An external relay isolated electrically from the ACT10
should be used for this purpose.
Don't forget to change the programming code to some-
thing known only to yourself.
IMPORTANT
As with any access control system, always ensure that there is
an alternate means of escape in the event of the unit failing to
operate due to power loss or in the event of fire.
Unit 8, IDA Business Park,
Whitestown, Dublin 24, Ireland.
Tel: 353-1-4622585 Fax: 353-1-4622587
Copyright 1999 Access Control Technology Ltd.
For full details on the ACT product range and a list of distributors,
Visit our website www.accesscontrol.ie
the on guide programming
please keypad, the of features
on information For
and mode gramming
time any at condition default
be may keypad The Note:
ready now is keypad The
flashing. stop
The button. X the Press
Programming Exit
programmed now is riod
Press period. desired the
the Allow 0. then 2, Press
Relay Desired Set
digits). (four code ming
followed % then 0, Press
Programming Change
digits) (four
followed 1 then 0, Press
code. 1 User Change
indicator yellow The
(9999) code
followed button X Press
Programming Enter
typical (for
SECOND 30
(18-00001-02)
5.
4.
3.
2.
1.
Downloaded from: http://www.guardianalarms.net
ACT10 DIGITAL KEYPAD