Throttle Grip; Hazard Warning Switch; Starter Switch - HYOSUNG GT 650 EFI Owner's Manual

WARNING
Apply the brake lightly and with great
care on slippery surfaces to avoid skid-
ding.
③ ③

THROTTLE GRIP

Engine speed is controlled by position of
the throttle grip. Turn it toward you to
increase engine speed. Turn it away from
you to decrease the engine speed.
WARNING
Avoid turning the throttle grip during
brakes.
④ ④

HAZARD WARNING SWITCH

◉ "
" : All four turn signal lamp and
indicator lamp will flash simulta-
neously when the switch is turn
on with the ignition switch in
" ON " position.
◉ "
" : The turn signal lamp and indi-
cator lamp go off.
Use the hazard warning lamps to warn
other traffic during emergency parking or
when your vehicle could otherwise become
a traffic hazard.
⑤ ⑤

STARTER SWITCH

Use this switch to operate the starting
motor.
With the ignition switch in the "ON" posi-
tion, the engine stop switch in the "
position, and the transmission is in neutral,
pull in the clutch lever and side stand up
and push the starter switch to start the
engine.
Do not engage the starting motor for
more than five seconds at a time as it
may overheat the wiring harness and
starting motor.
If the engine does not start after several
attempts, check the fuel supply and igin-
tion system. (Refer to Page 77)
WARNING
The
with the side stand ignition interlock
system.
If the transmission is in neutral or side
stand up, you can only start the engine
with pulling in the clutch lever.
This side stand ignition interlock system
prevents the motorcycle from being
started with side stand down.
Make sure that the side stand igintion
interlock system is working properly
before riding.
These motorcycles always come on the
head lamp, position lamp, meter lamp,
tail lamp and license plate lamp when
starting the engine.
"
36
CAUTION
are equipped
CAUTION