Table of Contents
Advertisement
96
To control your DV camcorder using the Control bar:
1. Make sure your DV camcorder is connected to your system and that the
proper Device control and Capture plug-in have been set.
2. Click the appropriate button on the Control bar to control your DV
camcorder within MediaStudio Pro:
• Fast Rewind
video.
• Fast Forward
video.
• Previous Frame
• Next Frame
• Start
• End
• Repeat
• Mark-in
selection.
• Mark-out
selection.
Direct MPEG capturing from a DV camcorder
You can directly capture MPEG files from your DV camcorder by switching
your capture plug-in to Ulead DSW MPEG Plug-in. This makes MPEG
capturing easier and hassle-free.
To directly capture to MPEG format:
1. Connect your DV camcorder to your IEEE-1394 interface card.
Note: When acquiring video from an analog source, be sure that the analog
capture card you are using supports RGB or YUV capture.
2. Turn your camcorder on and set it to Play mode (or VTR/VCR mode).
MEDIASTUDIO PRO USER GUIDE
to quickly go to the frame(s) near the beginning of the
to quickly go to the frame(s) near the end of the
to go to the frame prior to the current one.
to go to the frame following the current one.
to go to the first frame of the video.
to go to the last frame of the video.
to play the video in a continuous loop.
to set the current frame as the starting point of a video
to set the current frame as the ending point of a video
Advertisement
Table of Contents
