Adjusting Color With Your Video Capture Board - Ulead MEDIASTUDIO PRO 7 User Manual

82
Note: If you cannot satisfactorily calibrate your hardware, you can still artificially
readjust the video clip (after it's been successfully captured) using the Color
Calibration command in Video Editor (see page 156).
Typical calibration settings
At 75% amplitude, with 100% saturated RGB color bars, your color values
should resemble the following:
Red
Green 191
Blue
When looking at a composite waveform in the waveform monitor, the
typical settings are about:
Note: White and black should always be 100 and 0 respectively, though the other
colors may vary slightly.

Adjusting color with your video capture board

If you cannot use color calibration, your video capture board should still
provide controls that allow you to adjust the contrast, color, and position
of any video displayed from an external video source. The Video Display
button on the Standard toolbar and the Setup: Video Display or Setup:
Video Source command (depending on your video capture board) give you
access to these controls. If you are not sure how to use them, refer to the
documentation that accompanied your video capture board.
MEDIASTUDIO PRO USER GUIDE
White Yellow Cyan
191 191 0
191 191
191 0 191
White Yellow Cyan
100 65 50
Green Magenta
0 191
191 0
0 191
Green Magenta
50 30
Red Blue Black
191 0 0
0 0 0
0 191 0
Red Blue Black
20 20 0