Table of Contents
Advertisement
Marking video sequences for capturing
If you have a DV device installed (e.g. DV camcorder via IEEE-1394
FireWire interface card), you can control this device directly from Video
Capture. For example, clicking Rewind on the Control bar rewinds your
video tape. The main advantage of a controllable device is that you can
accurately specify which frames in a video to capture.
To mark video sequences using a DV device:
Click Setup: Device Control to open the Device Control dialog box.
1.
Specify the type of controllable device you have in the Current device
2.
combo box. Click Options if you need to define more parameters for the
selected device control driver. (Visit Ulead's web side to know more
about recommended settings for different device control drivers.)
Click Setup: Switch Capture Plug-in and select the appropriate capture
3.
plug-in.
Click Capture: Reel Properties and in the Reel Properties dialog box,
4.
type a name for the source tape in the Reel name entry box. (You can
assign any name, but be sure to change the name when you change the
source tape.)
In the File name entry box of the Reel Properties dialog box, enter a
5.
name for the captured video. Video Capture automatically appends a
number for each successive file created. For example, if the file name
you specify is called
and so on.
VID 0002
When you are ready to start marking video sequences, click the Preview
6.
button in the Standard toolbar or View: Preview.
Use the buttons in the Control bar to roll the source tape to the location
7.
where you want to begin marking video clips to capture.
8. Click the Play button to play the source tape.
VIDEO CAPTURE: CHAPTER TWO
"
"
, captured files will be called,
VID
109
,
VID 0001
Advertisement
Table of Contents
