IBM 72335LU - System x3850 M2 Installation Manual page 44

(BMC) and is assigned two MAC addresses. For information about configuring the
controller, see the Broadcom NetXtreme Gigabit Ethernet Software CD that comes
with the server.
Remote Supervisor Adapter II controls, connectors, and LEDs: These controls,
connectors, and LEDs are used for systems-management information and control.
Ethernet connector
(RJ-45)
The following controls, connectors, and LEDs are on the Remote Supervisor
Adapter II:
v Adapter activity LED: When this LED is flashing, the Remote Supervisor
v Power LED: When this LED is lit, the Remote Supervisor Adapter II is receiving
v Reset button: (Trained service technician only) Insert and press the open end of
v Mini-USB connector: This connector is not supported.
v Video connector: Use this connector to connect the server monitor.
v Ethernet connector (RJ45): Use this connector to connect a Category 3 (10
v External power-supply connector: Use this connector to connect an external
v ASM connector: This connector is not supported.
Power supply 1 connector: Connect the power cord to this connector.
32
IBM System x3850 M2 and System x3950 M2 Type 7141: Installation Guide
ASM connector
External power
supply connector
Video connector
Adapter II is functioning normally. When this LED is lit continuously, there is a
problem with the Remote Supervisor Adapter II. When the LED is off, the Remote
Supervisor Adapter II is not functioning.
power from the server, or from an external power-supply.
a paper clip (or similar object) into the recessed reset button to manually reset
the Remote Supervisor Adapter II.
Mbps) or Category 5 (100 Mbps) Ethernet cable to enable a LAN connection.
power-supply to the Remote Supervisor Adapter II.
Adapter activity LED
Power LED
Reset button (recessed)
Mini-USB connector