Physical Installation Of Your New Cd-Rw Drive - Yamaha CRW2100SZ - CRW - CD-RW Drive Quick Start Manual

SLAVE • Leave the jumper switch at SAVE postion if:
• Your new Yamaha CD-RW drive will be connected to the secondary E-IDE controller (to
which your system's existing CD-ROM or DVD-ROM drive is connected). This is the most
common configuration and you are recommended to connect your new CD-RW to your
computer's secondary E-IDE controller.
• You intend to connect your new CD-RW drive to your computer's primary E-IDE controller
(to which your computer's hard disk is connected).
To connect your new CD-RW drive to the secondary E-IDE controller (your CD-ROM or DVD-
ROM is likely connected to the secondary E-IDE controller), you do not need to change the
default setting (SLAVE). Changing the setting to the MASTER position will provide your new
Yamaha recorder priority over your existing CD-ROM or DVD-ROM drives.
CSEL - Cable SELect or CSEL is a function that automatically selects the correct MASTER/
SLAVE setting. Not all computers support CSEL. Use the CSEL position only if you are sure
your computer supports CSEL.
Important Note: If installing your new Yamaha CD-RW drive in a PC equipped with a CD-ROM or DVD-ROM
drive that features CSEL (in which case the jumper switch on that drive will be set on CSEL), you may encounter
problems (such as a blue error screen) when attempting to record a CD using a CD recording software. In such
a case turn off your computer, remove the cover, and then reposition the jumper switch of your existing
CD-ROM or DVD-ROM drive from its CSEL configuration to the MASTER setting. Leave your new Yamaha
drive's setting on SLAVE. If still encountering problems, set the DVD-ROM drive to SLAVE & set the Yamaha
drive to MASTER.
5. PHYSICAL INSTALLATION OF YOUR NEW 3-IN-1 CD-RW DRIVE
Make sure the following items are ready before proceeding with the installation of your
new CD-RW drive (see illustration).
• Phillips screwdriver
• Installation CD-ROM disc
Installing your new Yamaha 3-in-1 CD-RW drive is quite simple. Please follow the instruc-
tions on the next page patiently, step-by-step.
1. Before attempting to install your 3-in-1 CD-RW drive, turn off your computer by flipping
the power switch to the OFF position. Unplug the power cord as well.
• A pair of pliers
• This Quick Start Guide
O F F
PUSH
15
• Yamaha 3-in-1 CD-RW drive
/
D A E R
E T R I / N
W C O
S D I
L O V