This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. 2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables.
Laser Product Class: Class 1 Laser Diode Properties Wavelength: 780-787 nm Pulse Durations and Max. Output at the lens of the Laser Pickup Unit Read Mode: 0.7mW (Continuous) Write Mode: Max. 38mW (for 166ns, Min. Cycle 86.6ns) Laserprodukt-Klasse: Klasse 1 Eigenschaften der Laserdiode Wellenlänge: 780-787 nm Impulsdauer und max.
Yamaha dealer (listed at the back of this manual). G Make sure the computer is electrically grounded to avoid the risk of electrical shock.
For service information, and about service charges, contact the store of purchase, or your nearest Yamaha dealer (listed in the back of this manual). G Do not allow the plug of the AC adapter to come into contact with metal as a short circuit can result and cause a malfunction or damage to the device.
I Precautions for Transportation Keep the original box for future transportation. Before transporting the device, always put it in the original box. Yamaha does not bear any responsibility for any problem that occurs during transportation with the device not in the original box.
CD-R discs from going to waste. ( ¡ P. 3) Optimum Write Speed Control Before writing to a CD-R, the CRW2200UX drive checks the disc’s capability and automatically selects the optimum writing speed for greater reliability. The speed you set is the maximum writing speed.
High-fidelity digital audio The CRW2200UX drive supports extraction of digital audio data at up to 40X speed, as well as the recording of digital sound with complete fidelity even when writing at 20X speed. CD TEXT support Information such as the song name or artist name can be recorded on Audio CDs using CD creation software.
A Buffer Underrun Error will permanently ruin the disc. Yamaha Buffer Underrun Protection Buffer Underrun Protection is featured in Yamaha’s CRW2200 series CD-R/ RW drives. When a buffer underrun is about to occur, a buffer underrun error is prevented by temporarily suspending the writing process. Writing resumes when enough data has accumulated again in buffer memory.
• CD-ROM drive Notes • To install the device drivers, you need a CD-ROM drive other than the CRW2200UX drive. • The CRW2200UX drive cannot be used as a boot drive. Furthermore, the CRW2200UX drive cannot be used to set up the OS one more time.
PC. For details, refer to the separate manual, “Device Driver Installation Guide”, that came with the CRW2200UX drive. • The CRW2200UX drive cannot be used with a system that has been booted on MS-DOS or Safe mode. CD Writing Software The CRW2200UX drive requires a CD writing software to write onto a CD-R/RW disc.
The CRW2200UX drive can write to discs that carry the following logos: CD-R discs The CRW2200UX drive can write to these discs at 1X, 2X, 4X, 8X, 12X, 16X, or 20X speed. These discs can be played back in a CD-ROM drive or a CD player.
In other words, in CAV writing, the outer portion has an increased data transfer rate. The CRW2200UX drive uses the CAV method in the inner portions as well as the CLV method in the outer portions (Partial CAV) in order to enable up to 20X-speed writing.
CD-RW disc, the Full CAV method is recommended. Serial Number When you take the CRW2200UX drive out of its packaging, you should immediately write down the serial number found at the bottom of the drive with the bar code. You may need to refer to this number when requesting Customer Support services.
Adjust this control to set a suitable volume level when listening to an audio CD using the headphone jack. Slide the knob to the left to decrease the volume and to the right to increase it. ➆ ➆ ➆ ➆ Indicates the operation status of the CRW2200UX drive. ( ➂ ➃ ➆...
➀ ➀ ➀ ➀ LINE OUT jacks (L/R) To listen to audio CDs with the CRW2200UX drive, connect these to the line level input (LINE IN) of the stereo equipment with a standard stereo phono cable (sold separately). ➁ ➁ ➁ ➁...
Make sure that system configuration (CPU, RAM, OS, etc.) of your computer meets the requirements of the CRW2200UX drive. (¡ ¡ ¡ ¡ P. 4) Does your computer have a USB port with USB 2.0? Set up the CRW2200UX drive.
STEP 1 1 1 1 Turn on the computer. 2 2 2 2 Make sure that the power switch on the rear panel of the CRW2200UX drive is set to STANDBY. 3 3 3 3 Connect the included USB cable with the CRW2200UX drive.
Setup Procedures 4 4 4 4 Connect the included AC adapter to the DC-IN connector of the drive with the arrow on the adapter plug facing left, as shown below. 5 5 5 5 Connect the included power cable to the AC adapter (➀ ➀ ➀ ➀ ). Connect the other end of the power cable to the AC outlet (➁...
Setup Procedures 6 6 6 6 Turn on the CRW2200UX drive. When the power of the CRW2200UX drive is turned on, the power LED on the front panel lights up in green. Power LED...
• Be sure to connect the drive to the USB port of the interface card. If you connect the drive to the computer via a hub, the drive may not operate properly. • When the CRW2200UX drive is connected to a USB 1.1-compliant port on your computer, it operates in accordance with USB 1.1 standard.
Configuring for the Operating System STEP After connecting the CRW2200UX drive to the computer, you can verify that the drive is correctly recognized by your computer. For Windows 98 Second Edition/Me Select Control Panel, System, and open the Device Manager tab.
You can load and eject a disc (as described below) only when the CRW2200UX drive is turned on. 1 1 1 1 Open the disc tray by pressing the eject button on the CRW2200UX drive’s front panel. 2 2 2 2 Place the disc onto the disc tray with its label or printing facing upward, or remove the disc from the disc tray.
3 3 3 3 Push the tool gently into the manual eject hole until the spring-loaded mechanism ejects the disc tray and disc. 4 4 4 4 Turn on the CRW2200UX drive to close the disc tray. Manual eject hole...
Disconnecting the CRW2200UX Drive The CRW2200UX drive can be connected or disconnected to or from your computer at any time whether the computer is turned on or off (hot swapping). When removing the CRW2200UX drive with the computer turned on, or when turning off the drive with the computer connected, follow the procedure below.
Is the USB interface card installed correctly? Refer to the documentation that came with your USB interface card. The CRW2200UX drive is not recognized by the operating system. (¡ ¡ ¡ ¡ P. 16) Is the CRW2200UX drive correctly connected to the computer, using the...
The disc tray does not open. Is the CRW2200UX drive turned on? The power LED on the front panel of the CRW2200UX drive should light up when power is turned on. Is any CD writing software being used? Some CD writing software locks the eject button while it is running on a computer.
Note that no data can be read from any blank discs, and also that the CRW2200UX drive may sometimes fail to read data correctly from a disc even if the disc is compatible with the drive.
For Windows Me, if no sound can be heard through the headphones connected to the headphone jack of the CRW2200UX drive or through the speakers with a built-in amplifier connected to the LINE OUT jacks (L/R) on the rear panel of your drive, perform the following steps to change settings.
Notes • When the CRW2200UX drive is connected to a USB 1.1-compliant port on your computer, it operates in accordance with USB 1.1 standard. For CD writing software settings, it is advisable to activate the Buffer Underrun Protection and to set the data writing speed to 8X.
Appendix Recording Methods Disc-at-Once (DAO) This method is used to write all data onto a disc in one operation. This method writes multiple pieces of data successively without placing space between them, starting in the innermost track of the disc. Once data is recorded by this method, no data can be added to the same disc even if there is enough space left on it.
Appendix Track-at-Once (TAO) This method is used to write data on a disc on a track-by-track basis. A track can be defined as the smallest unit of area that contains an ordinary program, pictorial data, text data, etc. This method allows you to add data to the same disc, one track of data at a time, as long as there is free space left on the disc.
Packet Writing This method is used to record data onto a disc on a file-by-file basis. This method divides a track into small segments called “packets” so that data can be written on a packet-by-packet basis, which means that you can record data in much the same way as you copy data to a floppy or hard drive by dragging and dropping it on your desktop.
URL: http://www.yamaha-it.de/ The most up-to-date user support information, including information about the firmware, is available from the above YAMAHA CD-R/RW Drive web site. Please visit the YAMAHA web site regularly to check this information. Checking the Firmware Version of the CRW2200UX Drive...
LED Indicator Messages The following table shows the various LED signals and meanings when the CRW2200UX drive is turned on. Status Ready (with disc) Ready (no disc) Tray operation (opening/closing) Tray fully opened Reading disc information (TOC) Initial access in writing...
Appendix CRW2200UX Specifications Supported Formats CD-DA CD TEXT CD-ROM (*1) Mixed Mode CD-ROM (CD-ROM+CD-DA) CD-ROM XA (*1) Photo CD (*1) Video CD CD-i CD EXTRA (*1) *1: includes multisession *2: suitable disc required Note Excludes ADPCM Encode/Decode & Video Encode/Decode functions.
Data Capacity Data Transfer Rate (Mode 1) Data Buffer Size Average Random Access Time Sector Size Interface Burst Transfer Rate Installing Style Disc Loading Type Audio Out Power Consumption Operating Environment Dimensions (includes projection) Weight 700 MB (79 min.) 650 MB (74 min.) 550 MB (63 min.) 150 KB/sec.
Rated Input Current Rated Output Voltage Rated Output Current Terminal Output Polarity Operating Environment Dimensions (includes projection) Weight (includes the power cable) The CRW2200UX series complies with the following specifications Compliance Specifications Country / Region Category Safety Electrical Laser Emission Canada...
... 16 Data CD ... 7 DC-IN connector... 10, 13 Disc tray ... 9, 18 Disc-at-Once (DAO)... 26 Disconnecting the CRW2200UX Drive ... 20 Disk image files ... 5 Eject button ... 9, 18 Ejecting a Disc ... 18 Ejecting a Disc in an Emergency ... 19 Extraction of digital audio data...
Unplug or Eject Hardware ... 20 USB 2.0... 1 USB 2.0 Interface Card... 4 USB cable ... 5, 12, 15 USB port ... 10, 12, 15 Video CD ... 7 YAMAHA CD-R/RW Drive web site ... 4, 6, 11, 21, 29...
Bei weiteren Fragen wenden Sie sich Sitte an Ihren Händler oder eine der folgenden Firmen. Pour plus de détails sur les produits, veuillez vous adresser à Yamaha ou au distributeur le plus proche figurant dans la liste suivante : Si tiene alguna pregunta, por favor póngase en contacto con su distribuidor o una de...