Yamaha CRW2100SZ - CRW - CD-RW Drive Quick Start Manual page 22

16. Make sure the connector attached to your existing CD-ROM drive is still tight and has
not become loose during installation.
17. Locate one of the available DC power connectors inside your computer. Power connectors
are usually 4-pin extension with yellow. red and black wires. Connect this cable to the
power supply input of your 3-in-1 CD-RW drive, as illustrated below.
18. Carefully slide your new 3-in-1 CD-RW drive into the bay. Locate the screw holes
on the drive and match them against the screw holes in the chassis. Insert all 4, 3mm
mounting screws and washers from the sides and tighten them. Be careful not to
drop any of the screws or washers inside the computer.
A U D
IO O
U T
D IG IT
A L
A N A
L O G
D G
R G
L
A U D
IO O
U T
D IG IT
A L
A N A
L O G
D G
R G
L
4-pin power cable
IDE cable
21
Color Mark
Top Top
Bottom