Chapter 2 - Installing Theyamaha Crw4416S Drive; Crw4416S Drive Settings - Yamaha CRW4416S - CRW - CD-RW Drive User Manual

Chapter 2 - Installing theYamaha CRW4416S Drive

Before installing the CRW4416S in your Computer, you will need to set
the following jumpers.
SCSI ID settings
l
Parity setting
l
Terminator setting
l
Block size setting
l
This setting is set by inserting a jumper pin in the jumper switch
located
Important: Ilse lang-nose pliers to remove or insert jumper connectors.
In the diagrams in this manual, solid blackfill is used to indicate loca-
Rear Panel
n SCSI ID settings
The SCSI ID number is used so that the Computer will recognize a con-
nected
Usually, "7" is reserved for the SCSI card ID number, and "0" is
reserved for the first SCSI device in the chain.
Use a number between 1 and 6 for the CRW44 16s. Refer to the diagram
below for more information on setting the SCSI ID number. The factory
set ID number is "3".
Important: you are using other SCSI devices, be Sure to use a unique ID number
Chap ter 2 - Ins talling the Yamaha CR W44 16s Drive
rear Panel of the CRW4416S drive.
on the
Jumper Switch
SCSI device. You tan assign 0 through 7 as the SCSI ID number.