Table of Contents
Advertisement
CHAPTER 10 ---- Special Operating System Notes
NOTE:
The following section pertains only to PC users who use Microsoft's
Windows NT Operating System.
Windows NT 3.1 and above
YOUR TASK:
Install Windows NT from your CD-ROM drive. Or,
if you already have installed NT, add CD-ROM
support.
YOUR OBJECTIVE:
Utilize full capabilities of NT on your computer.
YOUR METHOD:
Check to see if your SCSI interface board is
included on NT's list of supported hardware.
Follow Microsoft's installation instructions.
Installation Procedure
To install Windows NT from your NT CD-ROM disc, you first need to verify that your
SCSI interface board is supported by NT. Check your NT manual for information on
which SCSI interface boards NT supports.
If your SCSI interface board is on NT's list of supported hardware, you can follow the
installation instructions provided by Microsoft.
However, if your SCSI interface board is not on NT's list of supported hardware, you
must contact your board's manufacturer and request an NT software device driver
(see listing of key contact phone/fax/BBS numbers on page 65).
The files you obtain need to be added to the NT installation floppy disk(s) that came
with your NT CD-ROM disc. Your SCSI interface board manufacturer will provide
you with specific installation instructions.
Adding CD-ROM Support After NT Has Already Been Installed
1) You first need to verify that your SCSI interface board is supported by NT.
Check your NT manual for information on which SCSI interface boards NT
supports. If your SCSI interface board is included on the list of supported
hardware, skip to #3.
2) If your SCSI interface board is not on NT's list of supported hardware, you
must contact your board's manufacturer and request an NT software device
driver (see listing of key contact phone/fax/BBS numbers on page 65).
40
PX-63CS/PX-65CS OPERATION MANUAL
Advertisement
Table of Contents
