Table of Contents
Advertisement
FWB Toolkit Macintosh
Device Driver Installation
1) To begin installation, insert the FWB floppy disk into your disk drive. Make
sure that power to your CD-ROM drive is OFF.
2) Drag each icon from the driver window into your SYSTEM FOLDER or use
the Installation program if one is available on the floppy.
SYSTEM 7 USERS: At this point a dialog box will appear telling you that these files
need to be stored in special places in the SYSTEM FOLDER. Click on OK and all the
files will be copied to their appropriate places.
SYSTEM 6 USERS: All files already are where they need to be. No further commands
are necessary.
3) Select ''Shut Down'' or ''Restart'' from your Mac desktop. After restarting your
Mac you should see the CD-ROM device driver as the Mac boots up. If the
icon appears crossed-out, check to see that the CD-ROM drive power is on
and that the SCSI ID does not conflict with another device. Otherwise, wait
until the Mac is done booting up before inserting a disc.
4) Insert a caddy containing a CD-ROM disc (written in Mac format) into your
6PleX drive.
5) Your Mac will display the CD-ROM disc's icon.
6) Double click on the icon to start the program.
CHAPTER 9 ---- Software Installation
PX-63CS/PX-65CS OPERATION MANUAL
37
Advertisement
Table of Contents
