Plextor PL-6P2 Operation Manual page 20

boards OS/2 supports. If your SCSI interface board is included on the list of
supported hardware, you can skip to step #3.
2) If your SCSI interface board is not on OS/2's list of supported hardware, you
must contact the manufacturer of your board and request an OS/2 software
device driver. (See listing of key contact phone/fax/BBS numbers on page
65.)
3) Once you have confirmed that your SCSI interface board is supported by
OS/2, or you have obtained the necessary device driver files, run OS/2's
Selective Install program to set up your SCSI interface board and CD-ROM
drive. In the ''SCSI Host'' field, select your board. (If your board already was
installed and running, your SCSI interface board should already be selected,
and there is no need for you to change this entry.) In the ''CD-ROM Drive''
field, select ''Texel/Plextor 3024/5024, 3028/5028, 4PleX." Then, select
''Install'' and insert the OS/2 floppy disks when requested. After rebooting,
your CD-ROM drive should appear in the ''Drives'' folder.
OS/2 Troubleshooting Tip:
If you have difficulty getting OS/2 to recognize your CD-ROM drive and SCSI interface
board, you first should verify that all of your hardware is operating properly.
This is best done by installing DOS. If your system also does not work under DOS,
you probably have a hardware problem that needs to be resolved before you can go
any further. Refer to the Troubleshooting guide in Chapter 13. If your system works
under DOS, but not OS/2, review your device driver installation and verify that the
SCSI interface board driver and CD-ROM support (step #3, above) is loaded correctly.
CHAPTER 10 ---- Special Operating System Notes
PX-63CS/PX-65CS OPERATION MANUAL
39