Symantec NORTON GHOST PERSONAL EDITION User Manual page 19

Sourcing NetBIOS
The following steps explain the NetBIOS setup procedure.
1 Install network interface cards.
2 Once the network interface cards are installed, the two peer
machines need to be connected using cabling. The type and setup
of the connection will depend on your individual network
requirements. These can include converted twisted pair cables,
coaxial, hub, and MAU-based setups.
3 Run the Network Interface Card setup program and configure the
card.
4 Set up NetBIOS.
Here is an example of loading NetBIOS in your startnet.bat or
autoexec.bat:
LSL.COM
REM (Comment: replace NE2000.COM with your NIC driver)
NE2000.COM
IPXODI.COM
NETBIOS.EXE
An example of the net.cfg for an NE2000 NIC:
#set up the NIC
link driver NE2000
_int 10
_port 300
Select which computer is the master (the machine from which you
control the connection), and which is the slave (the other machine
participating in the connection). All operator input will be on the
master computer. See
choose which will be the master and which machine will be slave.
Setting up transfer methods
"Peer-to-peer connections" on page 18 to
19