Technician-Level - DURKOPP ADLER DAC BASIC - CLASS 271 MANUAL PART II V 12-2010 Operating Manual

1.1.2

Technician-level

The technician's level is unlocked by the following key combination:
When switching on the control unit and press the P button
time.
This allows access to the technician's level.
Press A+ to get into the technician's level.
L C P Min
Backtack
t 00 00 300
t 00 01 0
00 02 0
t
t 00 03 0
t 00 04 0
t 00 05 0
t 00 06 0
t 00 10 300
t 00 11 0
t 00 12 0
t 00 13 0
t 00 20 300
t 00 21 0
t 00 22 0
t 00 23 0
t 00 30 0
t 00 31 0
t 00 32 0
© 2010 Dürkopp Adler AG
Max Preset Unity
2500 1700 rpm
254 12 10°
254 12 10°
1 0 -
2 0 -
1 1 -
500 0 ms
2500 1700 rpm
254 12 10°
254 17 10°
1 0 -
4000 2800 rpm
254 22 10°
254 24 10°
1 0 -
1 0 -
2500 1200 rpm
1000 200 ms
and the reset button
Description
Start backtack speed
Pre-control angle when switchin g on the backtack magnet.
(Switchover of forward backward at the bartack)
Pre-control angle when turning th e backtack magnet off.
(Changing of backward forward at the bartack)
Start backtack with the position 0 of the pedal interruptible.
0 = off;
1 = on
Mode for the end of the start backtack.
0 = You sew further after the end;
1 = Machine stops and must be started by the pedal again;
2 = Thread performance after the start backtack
Pedal release only to an additional route A
0 = off;
1 = on
Delay time up to the speed release after the start backtack
End backtack speed
Pre-control angle when switchin g on the backtack magnet.
(Switchover of forward backward at the bartack)
Pre-control angle when turning the backtack magnet off.
(Changing of backward forward at the bartack)
Backtack magnet stays switched on (simple with the last
backward way final backtack and multiple backtack ends) till
the needle has been reached the Pos. 2.
0 = off;
1 = on
Start multiple backtack speed (only at the stuffing program)
Pre-control angle when switchin g on the backtack magnet.
(Switchover of forward backward at the backtack) (only at the
stuffing program)
Pre-control angle when turning the backtack magnet off.
(Change of backward forward at the backtack) (only at the
stuffing program)
Start backtack as a stuffing program.
0 = off;
1 = on
Ornamental backtack
0 = off;
1 = on
Ornamental backtack speed
Stop time at the ornamental backtack
II-5
Operating manual part II
at the same