100-299 - Host-Adapter Specific - Dell PowerEdge 2300 User Manual

3-22 Dell PowerEdge 2300 Systems User's Guide
Any error that occurs while the driver is initializing prevents it from loading. If an error
does occur, the driver causes the computer to beep and then display a numbered
error message:
xxx message
The xxx indicates the error code, and message is a descriptive line describing the
error. The error codes are divided into three categories:
000-099 — Non–host-adapter specific
100-299 — Host-adapter specific
300-999 — Reserved
Specific error codes, such as those in the following subsections, appear only if you
have installed the host adapters and drivers that generate them.
The following error codes alert you to error conditions caused by factors not related to
the host adapter:
000 Failed ParseDriverParameters call
A call to NetWare's ParseDriverParameters routine has failed for some unknown rea-
son. The command-line contains errors, or you pressed <Esc> at the port or slot
prompt.
001 Unable to reserve hardware, possible conflict
The driver failed in its attempt to reserve the host adapter's hardware settings (that is,
direct memory access [DMA] and interrupt request [IRQ] settings). Another card in
your system may be causing a conflict with the host adapter.
002 NetWare rejected card Failed AddDiskSystem call
The driver failed in its attempt to register the host adapter with NetWare. The file
server may not have enough memory.
003 Invalid command line option entered > option
An invalid option was entered on the command line. The invalid option that was
entered is also displayed.
004 Invalid command line, please enter correctly
The driver was unable to understand the command line options you entered. Be sure
you have entered these options correctly.
The following error codes alert you to error conditions caused by factors related to the
host adapter:
200 No host adapter found for this driver to register