Right Side Access Panel - Compaq ProLiant 8000 Maintenance And Service Manual
Proliant 8000 intel pentium iii xeon 700mhz servers
Hide thumbs
Also See for ProLiant 8000:
- Maintenance and service manual (215 pages) ,
- Technology brief (23 pages) ,
- White paper (18 pages)
Table of Contents
Advertisement
Right Side Access Panel
To remove the right side access panel:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Loosen the three side access panel screws on the front of the server. The center screw has
no knurling and requires a T-15 screwdriver.
3. Slide the right side access panel back, then pull it away from the chassis.
Figure 2-2. Removing the right side access panel
Reverse steps 1 through 3 to replace the right side access panel.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal
system components to cool before touching them.
CAUTION: When the server is powered on, the access panels must be installed for proper
system cooling. Otherwise, component stress and permanent damage may result.
Removal and Replacement Procedures 2-7
Advertisement
Table of Contents
Troubleshooting
