Removing The Right Side Access Panel - Compaq ProLiant 6000 Series Setup And Installation Manual

Removing the Right Side Access Panel

To remove the right side access panel:
1. If the server is on, place the server in Standby and disconnect the power
cord(s). See Chapter 2, "Server Installation."
2. Unlock and open the front bezels.
3. Loosen the two thumbscrews and the slotted Torx screw located on the
right side of the chassis.
4. Slide the right side access panel toward the rear of the unit 1.0 inch
(2.5 cm).
Figure 3-9. Removing the right side access panel
5. Pull and remove the panel to locate the processor board and the memory
expansion boards.
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
WARNING: To reduce the risk of personal injury from hot
surfaces, allow the internal system components to cool before
touching them.
CAUTION: Never operate the server with an access panel
removed or partially installed. Doing so will cause thermal
damage to the system and could void your warranty.
Compaq ProLiant 6000 Setup and Installation Guide
3-17