Setting Up Using Device Codes Scan - Dish Network VIP222 Remote Control Setup

222.book Page 64 Tuesday, July 25, 2006 1:30 PM
Chapter 9
Controlling Other Components
10
If the code doesn't work, repeat steps 3
through 9 with another device code
from the tables.
11
If you can't find a code that works try,

Setting Up Using Device Codes Scan

that follows.
Setting Up Using Device Codes Scan
If the code for your device is not listed in the tables starting on page 116, use this
procedure to scan the remote control's memory for the device code. In the instructions
below, the column on the left contains the instructions and the column on the right
provides additional information.
1
Turn the device on.
2
Press and hold the mode button until
all the other mode buttons light up, and
then let go of the button. The mode
button flashes.
3
For AUX mode only. Press 0 for a
second TV, or 1 for a second VCR,
or 2 for a tuner, or amplifier. Then press
the STAR (*) button.
4
Press POWER.
64
Instructions
Instructions
Additional Information
Try every code listed for your brand until one
works for your device.
Additional Information
Use the device's front panel buttons or its
remote control.
For example, hold TV for a TV until all of the
other mode buttons light. When you let go, TV
will flash.
This step is for programming which kind of
device that should be programmed in AUX
mode. If you're not programming in AUX mode,
skip to step 4.
This puts your remote in the scan mode.