Sending Discrete Power O N And Off - Dish Network VIP222 Remote Control Setup

222.book Page 70 Tuesday, July 25, 2006 1:30 PM
Chapter 9
Sending Discrete Power On and Off
Removing the Recover Button Channel Programming
The following instructions describe how to reset RECOVER to restore satellite TV viewing
by tuning your TV (or VCR) to channel 3, 4, and other inputs.
S D P O O
ENDING ISCRETE OWER N AND FF
Installers use Remote control discrete power ON and power OFF IR commands when
programming macro commands into universal remotes. Using an ON-only or OFF-only
command is more effective than a toggle ON/OFF command when trying to make sure the
satellite receiver is reliably in one state or the other. To use discrete power commands,
complete the following:
70