Dish Network VIP222 Remote Control Setup page 15

222.book Page 71 Tuesday, July 25, 2006 1:30 PM
•
•
•
•
•
•
T
IPS
If using a specific channel for TV2 (for example, channel 60), TV2's remote control
must be programmed with a TV2 channel/input before you can use RECOVER.
Place the channel sticker on the remote TV and write down the channel you use to
watch DISH Network programming. The stickers are inside the front cover of this
guide.
If you don't want to accidentally change channels on your TV or VCR, try
programming the remote control in Limited Mode as described on page 62.
Make sure you have a UHF antenna connected so you can use Remote Control 2.
See page 15 for instructions.
Q
UESTIONS
My remote doesn't control my receiver or other components. What should I do?
– Put the remote control is in the correct mode (page 62).
– Check the batteries (page 15).
– Check the remote control address (pages 59 and 65).
– Check the UHF antenna (page 15).
– Adjust the UHF antenna (page 60).
Why does my receiver change channels or display menus at random? Your
neighbor may have their remote control set on the same address. Change the
address on your remote control and receiver as described on page 58. If that doesn't
help, you may have to install a UHF attenuator as described on page 61.
Remote Controls
Tips
71